Connecting The Cuff To The Monitor; Applying The Cuff - AEG BMG 5610 Instruction Manual

English
124
3.

CONNECTING THE CUFF TO THE MONITOR

The cuff is attached to the monitor when it is packaged.
Should the cuff become unattached, align the two plugs
and four brackets of the cuff with the plug sockets and
bracket sockets of the monitor and press the cuff to the monitor until the
plugs and brackets are securely attached.
4.

APPLYING THE CUFF

a. Place the cuff around a bare wrist 1-2 cm above the wrist joint on the palm side of
the wrist.
b. While seated, place the arm with the cuffed wrist in front of your body on a desk or
table with the palm up. If the cuff is correctly placed, you can read the LCD display.
c. The cuff must be neither too tight nor too loose.
Note:
1. Please refer to the cuff circumference range in "SPECIFICATIONS" to make sure that the ap-
propriate cuff is used.
2. Measuring on same wrist each time.
3. Do not move your arm, body, or the monitor during measurement.
4. Stay quiet, calm for 5 minutes before blood pressure measurement.
5. Please keep the cuff clean. If the cuff becomes dirty, remove it from the monitor and clear it by