Assembling Your Steam Mop; Using Your Steam Mop - Shark S2901UKCO Owner's Manual

Assembling Your Steam Mop

fig. 1
IMPORTANT: Always make sure the mop is
UNPLUGGED from the wall when not in use.
Never fill the mop, attach the mop head,
change or remove the cleaning pocket when
the mop is plugged into the wall. To prolong
the life of your Shark Multi-Function Steam
®
Pocket Mop Lite we recommend using
®
distilled water. Make sure you only add water
to the tank. Chemicals or cleaning solution
may damage the appliance and could be
unsafe for you and your family.
5 FREEPHONE 0800 862 0453
STEAM MOP ASSEMBLY
1 Insert the Mop Handle end with the " " facing the
front of the unit into the handheld steamer. Push the
mop handle in until you hear it click into place. (fig. 1)
2
Select the Rectangle or Triangle mop head and the
desired cleaning pocket. Fit one side of the pocket
onto the head first, then using the loop, pull the
pocket over the head. Attach the quick fasteners on
the top of the pocket to secure in place.
3
Snap the mop head into the mop body by lining up
the groove on the back of the mop body with the
groove on the back of the mop head. Push until you
hear it latch into place. Press the release button to
remove or change the mop head. (fig. 2)

Using Your Steam Mop

IMPORTANT: Make sure you do not use the
mop without attaching a cleaning pocket and
adding water to the tank first. When you are
using the mop for the first time, it might take
longer than the normal 30 seconds to start
steaming.
fig. 2
1
Turn the water tank cap counter clockwise and
remove from the tank. (fig. 3)
2
Use the filling flask and pour water into the tank. Do
not overfill. Replace the cap on the water tank.
(fig. 4)
IMPORTANT: Do not use on unsealed wood or
unglazed ceramic floors. On surfaces that have
been treated with wax or some no wax floors,
the sheen may be removed by the heat and
steam action. It is always recommended to test
an isolated area of the surface to be cleaned
before proceeding. We recommend that you
check the use and care instructions from the
floor manufacturer.
fig. 3
fig. 4
NOTE: To prolong the life of your Steam Mop, we
recommend using distilled water.
NOTE: Sweep or vacuum your floors prior to cleaning
with your Steam Mop.
3
Pull and twist the quick release cord holder to
unwrap the power cord completely. Plug into an
electrical outlet. (fig. 5)
4
Press the power button to turn the unit on. (fig. 6)
5
Clean your floors with a forward and backward
motion.
fig. 5
fig. 6
www.sharkclean.eu 6