Assembling Your Steam Pocket Mop - Shark NV642 Owner's Manual

Assembling Your Steam Pocket
fig. 1
WARNING: Always make sure the Steam Mop is
UNPLUGGED when not in use. Never fill the Steam
Mop or attach the mop head when the Steam Mop
is plugged into an electrical outlet. Unplug from
the electrical outlet and allow to cool before you
fill the mop, or attach or remove the head. To
prolong the life of your Steam Mop, we recommend
using distilled water. Make sure you add only
water to the tank. Chemicals or cleaning solutions
(including vinegar) may damage the Steam Mop
and could be unsafe for you and your family.
STEAM MOP ASSEMBLY
1
Screw the mop handle into the Steam Mop body
(screwdriver not included) (fig. 1).
2
Slide the Intelli-Mop
™
body. Push until you hear it click securely into place.
(fig. 1) To detach the Intelli-Mop Head, press the
release button on the front of the unit above the head
connection (fig. 1) and slide off.
7 1-800-798-7398
fig. 2b
fig. 4
Head post into the Steam Mop
Mop
®
fig. 2a
fig. 5
3
To attach the Dirt Grip
the floor with the pocket side up. Lift the mop and
center the Intelli-Mop Head above the pad, then
press down on the release buttons on the neck of
the steam mop head (fig. 2a). Both sides of the
Intelli-Mop Head will drop open (fig. 2b). Slip the
Intelli-Mop Head's four corner tabs into the four
corner pockets of the pad (fig. 3 and fig. 4). Gently
press one side of the Intelli-Mop Head to the floor
until that side clicks into place (fig. 5). Repeat on
the other side (fig. 6).
4
Open the water tank cap (fig. 7), fill the tank with
water, then replace and tighten the cap. Use the
filling flask and pour water into the tank (fig. 8). Do
not overfill. Replace the cap on the water tank.
fig. 7
fig. 3
fig. 6
pad, spread the pad on
™
fig. 8