Nokia N95-1 Owner's Manual page 124

Security settings for WEP:
• Wep key in use—Select the WEP key number. You can
create up to four WEP keys. The same settings must be
entered on the wireless LAN access point device.
• Authentication
authentication type between your device and the
wireless LAN access point device.
• WEP key settings—Enter
the key), WEP key format (ASCII
and WEP key
format).
Security settings for
• WPA/WPA2—Select the means of authentication:
EAP to use an extensible authentication protocol
(EAP) plug-in, or
Complete the appropriate settings:
• EAP plug-in settings
settings as your service provider instructs.
• Pre-shared key
password. The same password must be entered on the
wireless LAN access point device.
• TKIP encryption
whether Temporal Key Integrity Protocol (TKIP) is used.
Homepage—Define a home page.
Select Options >
following:
124
type—Select Open or Shared
WEP encryption
or Hexadecimal),
(the WEP key data in the selected
802.1x and WPA/WPA2:
Pre-shared key to use a password.
(only for EAP)—Enter the
(only for Pre-shared key)—Enter a
(only for WPA/WPA2)—Select
Advanced settings and from the
IPv4 settings:
device), Subnet mask
gateway (the gateway), and
addresses of the primary and secondary DNS server.
Contact your internet service provider for these addresses.
for the
IPv6 settings
known, or User
(length of
Ad-hoc channel
number (1-11) manually, select
Proxy server
server.
Proxy port number—Enter the proxy port number.
Packet data
The packet data settings affect all access points using a
packet data connection.
Packet data
and you are in a network that supports packet data, the
device registers to the packet data network. Starting an
active packet data connection (for example, to send and
receive e-mail) is quicker. If there is no packet data
coverage, the device periodically tries to establish a packet
data connection. If you select
uses a packet data connection only if you start an
application or action that needs it.
Phone IP address (the IP address of your
(the subnet IP address),
DNS address. Enter the IP
> DNS address—Select Automatic,
defined.
(only for Ad-hoc)—To enter a channel
User defined.
address—Enter the address for the proxy
connection—If you select When available
When needed, the device
Default
Well-