Table of Contents
Advertisement
15. Pass the leads from the servos through the
center hole in the sub firewall and into the battery
compartment. Holes have been made inside the
fuselage for the servo leads to pass through.
6
16. Plug the rudder and elevator servo leads into
the appropriate ports of the receiver.
17. Use two-sided tape to secure the receiver in the
fuselage as shown.
Stabilizer Installation
Required Parts
Fuselage
Stabilizer/elevator
Micro control horn Micro control horn backplate
Required Tools and Adhesives
Foam-safe CA
Hobby knife w/#11 blade
Felt-tipped pen
Ruler
T-pins
Pencil
1. Use a hobby knife with a #11 blade to remove
the hinge tape to fully expose the slot for the
elevator control horn. You may also need to
enlarge the plastic support piece slightly for the
control horn to fit. You want this slot to have a snug
fit, not a loose fit.
2. Slide the tab on the micro control horn through
the elevator from the bottom side as shown.
E-flite Nieuport 17 Slow Flyer Assembly Manual
Advertisement
Table of Contents
