E-flight Nieuport 17 250 Slow Flyer Assembly Manual page 5

 8. Use a pin drill and 1/16-inch (1.5mm) drill bit
to enlarge the outermost hole in the servo arm.
 9. Insert the micro pushrod connector into the servo
arm from the bottom of the horn as shown.
 10. Use a micro pushrod connector backplate to
secure the pushrod connector to the servo arm.
Use pliers to fully push the backplate tight on the
connector.
E-flite Nieuport 17 Slow Flyer Assembly Manual
11. Repeat Steps 7 through 10 so two servo arms

have been prepared for your servos.
12. Install the servo arm on the elevator servo. The

arm will be parallel to the center line of the servo
as shown.
13. Install the servo arm on the rudder servo. The

arm on the rudder servo is installed one spline off
from center so it will not interfere with the fuselage
during operation.
14. Slide the pushrod wires through the pushrod

connectors at this time.
5