E-flight Nieuport 17 250 Slow Flyer Assembly Manual page 19

5. Next, the rigging will go up and to the rear hole

in the outer strut as shown.
6. The rigging will now go through the rear tube in

the fuselage. Note that the rigging in this step must
be behind the rigging headed upward (Step 3).
E-flite Nieuport 17 Slow Flyer Assembly Manual
7. After exiting the tube, route the rigging up and

to the rear hole in the outer cabane strut as shown.
8. To complete the first stage of rigging, route it

down and forward through the hole the rigging
originally started at. Leave the end of the rigging
loose at this time and do not tie it to the strut.
9. The second stage of rigging is similar to the first.

Start by inserting the rigging thread through the
rear hole in the outer strut.
10. The rigging now heads to the cabane strut to

go through the rear holes in the strut. This line will
be in between the current rigging lines.
19