E-flight Nieuport 17 250 Slow Flyer Assembly Manual page 20

11. The rigging now heads to the rear hole in the

outer strut. Again, this line will be between the
current rigging lines.
12. Route the rigging up and to the forward hole in

the outer strut.
20
13. The rigging now goes down and through the

forward tube in the fuselage. This line will be in
front of all the other rigging lines.
14. After exiting the fuselage, route the rigging up

to the forward hole in the outer strut. Make sure
the rigging is in front of all the previously installed
rigging lines.
15. To complete the first stage of rigging, route it

down and forward through the hole the rigging
originally started at. Leave the end of the rigging
loose at this time and do not tie it to the strut.
16. Use the following images to verify the rigging

installation. The lines heading upward from the
fuselage to the outer struts should be on the
outsides (front and back) of the downward lines.
When tensioned, the lines will all run perfectly
straight and not cause others to be moved out of
position.
E-flite Nieuport 17 Slow Flyer Assembly Manual