E-flight Nieuport 17 250 Slow Flyer Assembly Manual page 13

2. Use a hobby knife and #11 blade to remove the

material from between each cylinder of the dummy
motor.
3. Locate the 6mm x 42mm carbon tube. Follow

the instructions included with the motor to glue
(using RTV silicone) the motor to the motor tube. Be
careful not to get glue inside the motor bearing.
E-flite Nieuport 17 Slow Flyer Assembly Manual
4. Use medium grit sandpaper to roughen the

outside of the carbon tube so the CA used to glue it
in the fuselage has a surface to attach to.
5. Mount the speed control using two-sided tape

to the front of the fuselage as shown below. Route
the servo lead back to the receiver and plug it into
the throttle port of the receiver. Use a tie wrap (not
included) to keep the wires from interfering with the
operation of the motor.
Leave the tie-wrap loose so the wires from the speed
control can be moved when installing the motor.
6. Connect the wires from the motor to the

appropriate wires of the speed control.
13