Top Wing And Outer Strut Installation - E-flight Nieuport 17 250 Slow Flyer Assembly Manual

6. Install the remaining wheel and secure it

following the procedure described in Steps 4
and 5.
E-flite Nieuport 17 Slow Flyer Assembly Manual

Top Wing and Outer Strut Installation

Required Parts
Airframe Top wing
Outer strut (2)
Required Tools and Adhesives
Hobby knife w/#11 blade Pin drill
Drill bit: 1/16-inch (1.6mm) Foam-safe CA
1. Use a hobby knife and #11 blade to remove

the foam from the notches in the wing for the outer
struts and cabane strut.
 2. Use a pin drill and 1/16-inch (1.5mm) drill bit,
or a hobby knife and #11 blade to remove any
clear coating that may be blocking the four holes in
each outer strut.
3. Use a pin drill and 1/16-inch (1.5mm) drill bit,

or a hobby knife and #11 blade to remove any
clear coating that may be blocking holes two holes
on either side of the cabane strut.
3. Place a piece of waxed paper on your work

surface. Place the top wing on the waxed paper.
Use foam-safe CA to glue the top wing to the
cabane strut.
17