E-flight Nieuport 17 250 Slow Flyer Assembly Manual page 15

11. Once the CA has cured. Remove the cowling.

Apply CA to the joint between the carbon tube and
fuselage at both the front and back of the tube to
glue it securely to the fuselage.
Important Information About Your Brushless ESC
Make sure your ESC brake is programmed
to Off. Also, be sure to use an ESC with
the proper low-voltage cutoff and it is set
correctly for the batteries you are using.
Never check the motor rotation on the bench
with the propeller installed. The plane could
move and cause serious injury. Always check the
motor without the propeller to avoid injury.
12. Turn on the transmitter and bring the throttle

trim and stick to the low throttle position. Plug
the battery into the speed control and check
the operation of the motor. It should rotate
counterclockwise when viewed from the front of
the aircraft. Use the instructions provided with your
ESC to make corrections to the direction of rotation
of the motor if necessary.
E-flite Nieuport 17 Slow Flyer Assembly Manual
13. Slide the cowling back on the fuselage. Use

the three 2mm x 8mm black wood screws and a
#1 Phillips screwdriver to attach the cowling to the
fuselage.
Important Information About Your Propeller
It is very important to check to be sure
the propeller is balanced before installing
onto the shaft. An unbalanced propeller
may cause poor flight characteristics.
14. Attach the propeller to the motor using the

materials and instructions provided with your
particular motor.
15. Use hook and loop tape to install the battery in

the fuselage as shown. Ensure the battery does not
touch the dummy motor.
15