Operation (Automatic And Manual Modes); Operating Hours Counter; Altering The Operating Hours Counter For The Grease Filters - Miele DA 2906 Operating And Installation Instructions

Operation (automatic and manual modes)

Operating hours counter

The number of hours the appliance has
been in operation is stored in memory.
When the grease filter symbol  or the
charcoal filter symbol  lights up, the
operating hours counters are signalling
that the filters need to be cleaned or
changed. Further information about
cleaning and changing the filters and
resetting the operating hours counter
can be found under "Cleaning and
care".
The operating hours counter settings
described in the following section can
only be carried out using the control
panel on the rangehood. They cannot
be carried out via the remote control.
Altering the operating hours counter
for the grease filters
You can set the operating hours
counter for the grease filters to suit the
type of cooking you do.
It is set at the factory for 30 hours.
– Select a shorter time (20 hours) if you
fry a lot.
– If you only cook occasionally, we
recommend that you still select a
relatively short time because grease
which has built up gradually over a
long period of time will harden on the
filters and make cleaning more
difficult.
– If you use very little fat for cooking,
select a longer time (40-50 hours).
 Press the On/Off touch control  to
switch the fan off.
24
 Press the run-on control 515 and
the operating hours counter  at
the same time.
The grease filter symbol  and one of
the fan power setting indicators will
flash.
Fan power setting indicators 1 to IS
show the time set:
1............................................... 20 hours
2............................................... 30 hours
3............................................... 40 hours
IS ............................................. 50 hours
 Press the "" symbol for a shorter
operating time, or the "" symbol to
select a longer operating time.
 Confirm the selection by pressing the
operating hours control .
All the indicator lights will go out.
If you don't confirm your selection
within 4 minutes, the rangehood will
automatically revert to the previous
setting.