Advertisement

Operating and installation instructions
Cooker hood
DA 270-4, DA 270-4 EXT
DA 270-4 U
DA 270-4 Alu, DA 270-4 EXT Alu
DA 270-4 U Alu
en - GB
To avoid the risk of accidents
or damage to this appliance
it is essential to read these
instructions before it is installed
and used for the first time.
M.-Nr. 07 260 790

Advertisement

Table of Contents
loading

Summary of Contents for Miele DA 270-4

  • Page 1 Operating and installation instructions Cooker hood DA 270-4, DA 270-4 EXT DA 270-4 U DA 270-4 Alu, DA 270-4 EXT Alu DA 270-4 U Alu en - GB To avoid the risk of accidents or damage to this appliance it is essential to read these instructions before it is installed and used for the first time.
  • Page 2: Table Of Contents

    Miele|home ........
  • Page 3: Caring For The Environment

    Caring for the environment Disposal of the packing Disposal of your old appliance material Electrical and electronic appliances often contain materials which, if The transport and protective packing handled or disposed of incorrectly, has been selected from materials which could be potentially hazardous to are environmentally friendly for human health and to the environment.
  • Page 4: Warning And Safety Instructions

    Warning and Safety instructions This appliance is not intended for This appliance complies with all use by persons (including children) relevant local and national safety with reduced physical, sensory or requirements. Inappropriate use mental capabilities, or lack of can, however, lead to personal injury experience or knowledge, unless they and damage to property.
  • Page 5: Technical Safety

    Technical safety Installation, maintenance and repairs may only be carried out by a Before installation, check the cooker Miele authorised person in accordance hood for visible signs of damage. with current national and local safety Under no circumstances should you regulations.
  • Page 6 These models may only be combined with a Miele external motor. This appliance may only be used in mobile installations such as ships, caravans, aircraft etc. if a risk...
  • Page 7 The Miele DSM 400 control module as ensuring that the cooker hood can offers the possibility of combining other only be switched on when the heating components with the cooker hood (see appliance is switched off or vice versa.
  • Page 8: Correct Use

    Warning and Safety instructions Correct use Do not use the cooker hood without the filters in place. This way you will Never use an open flame beneath avoid the risk of grease and dirt getting the cooker hood. To avoid the danger into the appliance and hindering its of fire, do not flambé...
  • Page 9 Safety regulations prohibit the fitting of a cooker hood over solid fuel stoves. All ducting, pipework and fittings must be of non-flammable material. These can be obtained from the Miele Spare Parts department or from builders' merchants. The appliance must not be connected to a chimney or vent flue which is in use.
  • Page 10: Guide To The Appliance

    Guide to the appliance...
  • Page 11: Guide To The Appliance

    Guide to the appliance Cover Touch control for the grease filter Tower The indicator lamp for the grease filters lights up when the grease filters need Control panel to be cleaned. Glass edge feature lighting The touch control is used to reset the Hob lighting operating hours counter every time the grease filters are cleaned (see...
  • Page 12: Modes Of Operation

    Modes of operation . . . air recirculation: The cooker hood works with (...U models only) . . . air extraction: (excluding ...U models) The air is drawn in and cleaned first by the grease filters and then by a charcoal filter.
  • Page 13: Miele|Home

    Miele electric hob with onset controls. This module must be installed by a Miele service technician or suitably For communication to take place, the qualified electrician.
  • Page 14: Operation

    If the cooker hood has been connected to a window contact switch via the Miele DSM 400 control ^ Press the run-on option control for module, then the fan cannot be approx. 10 seconds. The first fan switched on if the window is shut.
  • Page 15: Run-On Option

    Operation Run-on option It is advisable to run the fan for a few minutes after cooking has finished to neutralise any lingering odours in the The indicator lamps for fan power levels air, whether you are using air extraction I and IV will flash if the automatic or recirculation mode.
  • Page 16: To Switch The Hob Lighting On

    Operation To switch the hob lighting on Glass edge feature lighting The hob lighting can be switched on and off independently of the fan. The glass edge feature lighting can be turned on or off indepedently of the fan, using the left hand lighting control. ^ Briefly press the right hand lighting control to switch on the hob lighting.
  • Page 17: Filter Operating Hours Counter

    Operation Filter operating hours counter Reading the operating hours counter for the grease filters The number of hours the appliance has been in operation is stored in memory. To check the percentage of time set already used: The operating hours counter tells you when the grease filters or charcoal filter need to be cleaned or replaced.
  • Page 18 Operation Altering the operating hours counter for the grease filters The operating hours counter for the grease filters is set at the factory for 30 The - / + indicator lamps show the time hours. This can be lengthened or which has been set: shortened to suit the type of cooking 1st lamp from the left = 20 hours...
  • Page 19 Operation ^ Use the - /+ controls to select the Activating and altering the operating desired time. hours counter for the charcoal filter (...U models only) The charcoal filter is needed for recirculation mode. On delivery, the operating hours counter ^ Confirm the selection by pressing the for the charcoal filter is deactivated.
  • Page 20 Operation Reading the operating hours counter for the charcoal filter To check the percentage of time set already used: ^ Press the On/Off control to switch the fan on. ^ Press and hold the charcoal filter control. One or more of the indicator lamps for the - /+ controls will flash.
  • Page 21: Cleaning And Care

    It can Stainless steel surfaces can be cleaned be washed 300 times. using the Miele E-Cloth, or with a proprietary non-abrasive cleaning Housing agent designed specifically for use on stainless steel.
  • Page 22 Cleaning and care Important for appliances with Controls lacquered housing The controls may suffer (special order finish) discolouration or damage if soiling is left on them for too long. It is very difficult to clean this type of surface without causing minor marks to Remove soiling straight away.
  • Page 23: Grease Filters

    65°C programme, ensuring the spray arm is not obstructed. If a Miele dishwasher is being used, select the Sensor wash programme. ^ Use a mild dishwasher detergent.
  • Page 24: Charcoal Filter

    It is fitted in the canopy above the grease filters. New filters can be purchased from your Miele dealer or from the Miele Spare Parts Department. See back cover for contact details, and "Technical data" for the model number of the filter.
  • Page 25 Cleaning and care Always replace the charcoal filter im- mediately if – the indicator lamp for the charcoal filter lights up, – if it is no longer effective in absorbing kitchen odours. It should, however, be replaced at least every 6 months. Used charcoal filters can be disposed of with the normal household waste.
  • Page 26: Changing A Halogen Lamp

    Cleaning and care Changing a halogen lamp ^ Before any cleaning or maintenance work, disconnect the cooker hood from the mains supply. Ensure that – it is switched off at the isolator, or – the screw-out fuse is removed (in countries where this is applicable).
  • Page 27: Appliance Dimensions

    DA 270-4, DA 270-4 EXT 550 mm above electric hobs and cookers, 650 mm above an open grill or...
  • Page 28: Installation

    Installation Before installation, it is important to read the information given on the following pages as well as the 2 screws M4 x 8 mm "Appliance dimensions" and the for securing the tower. "Warning and Safety instructions" at the beginning of this booklet. This is particularly crucial when using the cooker hood at the same 4 spacers to use in the event of an...
  • Page 29: Connection For Air Extraction

    Connection for air extraction – Where ducting is horizontal, it must Important: To avoid the danger of be laid to slope away at at least 1 cm toxic fumes, please observe the per metre. Warning and Safety instructions. This is to ensure that condensate This is especially crucial when using cannot drain back into the cooker the cooker hood at the same time as...
  • Page 30: Condensate Trap

    Connection for air extraction Important! Cooker hoods designed for use with an external motor (...EXT models) have an If the exhaust ducting is to run through integrated condensate trap. rooms, ceiling space etc. where there may be great variations in temperature Silencer between the different areas, the problem of condensation will need to...
  • Page 31: Electrical Connection

    Electrical connection If the switch is not accessible after All electrical work should be installation (depending on country), an undertaken by a suitably qualified additional means of disconnection must and competent person in strict be provided for all poles. accordance with current national For extra safety it is advisable to install and local safety regulations a residual current device (RCD) with a...
  • Page 32: Operation With Dsm 400 Control Module

    Operation with DSM 400 control module The Miele DSM 400 control module can If the control module is be used to combine the cooker hood disconnected in order to operate the with other components. cooker hood without the window It enables the following: contact switch (e.g.
  • Page 33: Connection To A Light Switch

    Operation with DSM 400 control module Connection to a light switch The control module can be used to switch on the cooker hood lighting and also to dim it (depending on model) via a light switch in the house. Installation The control module is fitted in the tower after the cover plate has been unscrewed from the ceiling.
  • Page 34: After Sales Service

    In the event of a fault which you cannot correct yourself, or if the appliance is under guarantee, please contact: – Your Miele Dealer / Chartered Agent – The Miele Customer Contact Centre (see back cover for address). When contacting your Dealer or Miele, please quote the model and serial number of your appliance.
  • Page 35: Technical Data

    Weight DA 270-4....36 kg DA 270-4 U ....38 kg DA 270-4 EXT .
  • Page 36 Alteration rights reserved / 4209 M.-Nr. 07 260 790 / 02...

This manual is also suitable for:

Da 270-4 extDa 270-4 aluDa 400 ext

Table of Contents