Residual Risks; Markings On Tool - DeWalt D28715 Original Instructions Manual

• Check that the workpiece is properly supported.
• Use the cutting discs recommended by
the manufacturer only. Do not use tools for
purposes not intended; for example do not use
circular saw blade to cut tree limbs or logs.
• The max. allowable speed of the cutting disc
must always be equal to or greater than the
no-load speed of the tool specified on the
nameplate.
• Do not use cutting discs that do not conform to
the dimensions stated in the technical data.
• Read the operating instructions supplied by the
wheel manufacturer.
• Ensure that the abrasive wheel is correctly fitted
and tightened before use.
• Let the tool run at no-load in a safe position for
at least 30 seconds. If there is a considerable
vibration or if any other defect occurs, stop the
tool and check it to determine the cause.
• Do not use cutting discs for side grinding.
• Do not cut concrete, brick, tile or ceramic
materials.
• Do not cut wood, plastic or synthetic materials.
• Do not cut cast-iron materials.
• Never cut magnesium materials.
• Do not cut electrically live material.
• Use this tool in a well-ventilated area. Do not
operate the tool near flammable liquids, gases
or dust. Sparks or hot chips from cutting or
arcing motor brushes may ignite combustible
materials.
• Regularly clear the ventilation slots when
working in dusty conditions. If it should become
necessary to clean the slots, always use a soft
brush; remember to unplug the machine first.
• Always store cutting discs well-protected and in
a dry place, out of reach of children.
• Faults in machine, including guards or cutter
blades, should be reported as soon as they are
discovered.
• Only use chop saw wheel of a
a max. thickness of 3.1 mm
(0.12") and a max. diameter of
355 mm (14").
• Never use the machine in explosive
atmospheres and environments where sparks
could cause fire, explosion etc.
• Secure the machine to a bench, especially
when cutting heavy and extended workpieces.
WARNING! The wheel continues to
rotate after the machine is switched off.
WARNING! Use of this tool can
generate dust containing chemicals
known to cause cancer, birth defects or
other reproductive harm. Use appropriate
respiratory protection.
• The following factors are of influence to noise
production:
– the material to be cut
– the type of the cutting disc
– the feed force. Take appropriate measures
for the protection of hearing.
WARNING: We recommend the use of
a residual current device with a residual
current rating of 30mA or less.

Residual Risks

• The following risks are inherent to the use of
these machines:
– injuries caused by touching the rotating
parts.
– injuries caused by disruption of the cutting
disc.
• These risks are most evident:
– within the range of operation
– within the range of the rotating machine parts
• In spite of the application of the relevant
safety regulations and the implementation of
safety devices, certain residual risks cannot be
avoided.
These are:
– Impairment of hearing.
– Risk of accidents caused by the uncovered
parts of the rotating cutting disc.
– Risk of injury when changing the disc.
– Risk of squeezing fingers when opening the
guards.

Markings on Tool

The following pictograms are shown on the tool:
Read instruction manual before use.
Wear ear protection.
Wear eye protection.
Bore Diameter
English
7