Use The Power Cable Pcu-4 Or Ca-153P - Nokia CAR KIT CK-100 User And Installation Manual

I n s t a l l a t i o n
pins on the fuses of the ISO cable. Plug the ISO cable to the two
open ISO connectors.
2. Plug the ISO cable to the respective connector on the hands-free
unit.
3. Connect the stereo outputs of the hands-free unit to the AUX input
of the car radio. Use an appropriate cable specific to your car radio
(this cable is not supplied with the car kit).
4. Cut the loop indicated with scissors in the figure.
After you have connected the ISO cable and the stereo output cable,
connect the external input device CU-11 and the microphone MP-2 to
the respective connectors on the hands-free unit.
To charge a compatible Nokia mobile phone through the car kit, connect
one end of the supplied charging cable CA-134 to the hands-free unit
and the other end to the 2.0-mm (0.08 inch) charging connector of the
phone.

Use the power cable PCU-4 or CA-153P

In this setup, the car radio is muted when you make or receive a call.
The loudspeaker SP-3 is used for calls, and the amplifier and equaliser of
your car radio are used for music played on a connected device that
supports the A2DP Bluetooth profile.
Music played on A2DP devices and Nokia Maps navigation prompts
played on some Nokia device models are directed to the AUX input of
the car radio. To hear the music and prompts, select AUX input on the
car radio as the audio source. If the car radio does not have an AUX
input, the music and prompts played on these devices cannot be heard
22