Hotpoint RGB524EN Use And Care & Installation page 33

Table of Contents

Advertisement

HOW TO CONVERT THE RANGE
FOR USE WITH 1P GAS
CONVERT THE PRESSURE REGULATOR FOR LPGAS
1.
Remove the cooktop and locate the pressure
regulator at right rear of the range.
2. Determine which figure,
is appropriate for your regulator type.
If it is regulator
1.
Use a coin to remove the cap from the pressure
regulator.
2. Turn the cap over and engage it in the slots. LP
should now be visible on the top of the cap.
If it is regulator ~:
1.
Unscrew the plastic-protected hex-nut cap
•l
assembly from the top center of the regulator.
2. Carefully pry the protective plastic cap off the
threaded metal cap. Gently pull the plastic washer
off the other threads.
3. Replace the plastic cap onto the threaded end
displaying the gas type you desire. Press the
plastic washer onto the remaining threads.
4. Reinsert the cap assembly into the regulator.
Do not overtighten, but ensure the seating of the
washer.
If it is regulator
1.
Remove cap and forcibly snap out plastic
plunger from bottom of cap.
2. Turn plunger over and forcibly snap back in
original location. Note: Plunger must snap into
position; the gas type you are converting to must
be visible on lower side of plunger.
3. Reinsert the assembly into the regulator.
CONVERT SURFACE BURNERS FOR LPGAS
1.
Lift cooktop.
2. Lift burner assemblies straight up and set aside to gain access to
surface burner spuds.
3.
With a 5/16" wrench, remove each of the four brass spuds on the
surface burner gas inlet tubes, and replace them with the red-tinted
LP gas spuds mounted in a holder at the right rear of the range
above the regulator. (Mount the natural gas brass spuds in this
holder.) To prevent leakage, make sure spuds are securely screwed
into gas inlet tubes.
4. Replace the burner assemblies.
5.
Keep the natural gas spuds with your range
so you have them If you move or get a natural gas hookup.
,
or
:
:
WARNING:
Do
not remove the pressure regulator from the range.
,
Gas
Flow
NOTE: This valve
Electric Ignition
Do not remove this motectwe caD
appears on
models only.
33

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rgb528genRgb524pnRgb628genRgs525genRgb528en

Table of Contents