Hotpoint RGB524EN Use And Care & Installation page 18

Table of Contents

Advertisement

Special Care of
Continuous-Cleaning
Oven Interior
(on model RGB628GEN)
The Continuous-Cleaning Oven
cleans itself while cooking.
oven walls are finished with a
that cannot be
special coating
cleaned in the usual manner with
soap, detergents, steel wool pads,
commercial oven cleaners, coarse
abrasive pads or coarse brushes.
of oven sprays will cause permanent
damage.
The special coating is a porous
ceramic material,
which is dark in
color and feels slightly rough to the
touch. If magnified, the surftice
would appear as peaks, valleys and
sub-surface "tunnels?' This rough
finish tends to prevent grease
spatters from forming little beads
or droplets that run down the side
walls of a hard-surface oven liner,
leaving unsightly streaks that
require hand cleaning. Instead,
when spatter hits the porous finish,
it is dispersed and partially
absorbed. This spreading action
increases the exposure of oven
soil to heated air and makes it
somewhat less noticeable.
Soil may not disappear completely
and at some time after extended
usage, stains may appear that
cannot be removed.
The special coating works best on
small amounts of spatter.
not work well with larger spills,
especially sugars, egg or dairy
mixtures.
This special coating is not used
on oven shelves, oven bottom or
door liner.
Remove these to clean
with a commercial oven cleaner to
prevent damaging the Ccmtinuous-
Cleaning Oven coating.
18
(continued)
To Clean the Continuous-
Cleaning Oven:
1.
Let range parts cool before
handling. We recommend rubber
gloves be worn when cleaning.
The
2. Remove shelves and cookware.
3. Soil visibility maybe reduced by
operating the oven at 400°F. Close
the door and turn OVEN CONTROL
knob to 400°F. Time for at least
necessary before improvement in
e
appearance is apparent.
R
: DURING
EMEMBER
DOOR AND OTHER RANGE SURFACES
WILL GET H(YT ENOUGH TO CAUSE
BURNS. D() NOT "KXJCfi. LET THE
RANGE COOL BEFORE REPLACING
OVEN SHELVES.
4. If' a spillovcr or heavy soiling
occurs on the porous surface, as
soon as the oven has cooled,
remove as much of the soil as
possible using a small amount of
water and a stiff-bristle nylon
brush. Use water sparingly and
change it frequently. keeping it as
clean as possible, and be sure to
or sponges. Do
with paper towels, cloths or
sponges, since they will leave
unsightly lint on the oven finish.
If water leaves a white ring on the
finish as it dries, apply water again
and
with a clean sponge,
starting at the edge of the ring and
does
working toward the center.
THE
'THE OVEN, THE
scrub
rub or
I
Do not use soap, detergent,
steel wool pads, commercial
oven cleaner, silicone oven
sprays, coarse pads or coarse
brushes on the porous surface.
These products will spot, clog
and mar the porous surface and
reduce its ability to work.
Do not scrape the porous
surface with a knife or spatula—
they could permanently damage
the finish.
The oven bottom and the inside
of the oven door have a porcelain
enamel finish.
The oven door lifts
off and the oven bottom comes
out for cleaning away from the
Continuous-Cleaning Oven. See
pages 17 and 19.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rgb528genRgb524pnRgb628genRgs525genRgb528en

Table of Contents