Troubleshooting - Bosch AL 2204 CV Original Instructions Manual

OBJ_BUCH-190-006.book Page 7 Thursday, July 11, 2013 7:47 AM
Technical Data
Battery Charger
Article number
Output voltage (automatic voltage detection)
Charging current
Allowable charging temperature range
Charging time for battery capacity, approx.
– 1.0 Ah
– 1.3 Ah
– 1.5 Ah
– 2.0 Ah
Number of battery cells
Weight according to EPTA-Procedure 01/2003
Protection class
Please observe the article number on the type plate of your battery charger. The trade names of individual battery chargers may vary.
Operation
Starting Operation
 Observe the mains voltage! The voltage of the power
supply must correspond with the data given on the name-
plate of the battery charger. Battery chargers marked with
230 V can also be operated with 220 V.
Charging Procedure
The charging procedure starts as soon as the mains plug of
the battery charger is inserted into the socket and the battery
1 or the power tool with the slid on battery 1 is inserted on the
battery charger. The power tool cannot be switched on during
charging.
Firstly, place the battery 1 as shown in the figure onto the
front of the battery charger () and then press the battery 1
down at the rear (). To remove the battery, proceed in re-
verse order.
Due to the intelligent charging method, the charging condi-
tion of the battery is automatically detected and the battery is
charged with the optimum charging current, depending on
battery temperature and voltage.
This gives longer life to the battery and always leaves it fully
charged when kept in the charger for storage.
Note: The charging procedure is only possible when the bat-
tery temperature is within the allowable charging tempera-
ture range, see Section "Technical Data".
Meaning of the Indication Elements
Flashing Battery Charge Indicator 2
The charging procedure is signalled by a
flashing battery charge indicator 2.
Bosch Power Tools
AL 2204 CV
2 607 225 2..
V 14.4 – 21.6
mA 430
°C 0 – 45
100 %
min 150
min 180
min 207
min 290
4 – 6
kg 0.7
/ II
Continuous Lighting of the Battery Charge Indicator 2
Continuous lighting of the battery
charge indicator 2 indicates that the
battery is fully charged or that the
temperature of the battery is not with-
in the allowable charging temperature range, and cannot be
charged for this reason. The battery is charged as soon as the
allowable charging temperature range is reached.
When the battery is not inserted, continuous lighting of the
battery charge indicator 2 indicates that the mains plug is in-
serted in the socket and that the battery charger is ready for
operation.

Troubleshooting

Causes and Corrective
–
Measures
Cause Corrective Measure
Continuous lighting of the battery charge indicator 2
No charging procedure possible
Battery not (properly) insert- Properly insert battery into
ed battery charger
Battery contacts contaminat- Clean the battery contacts
ed (e.g. by inserting and remov-
ing the battery several times)
or replace the battery
Battery pack defective Replace the battery
Battery charge indicator 2 does not light up
Mains plug of battery charger Insert mains plug (fully) into
not plugged in (properly) the socket outlet
Socket outlet, mains cable or Check the mains voltage;
battery charger defective have the battery charger
checked by an authorised af-
ter-sales service agent for
Bosch power tools
English | 7
AL 2215 CV
2 607 225 4..
14.4 – 21.6
1500
0 – 45
100 %
45
55
63
85
4 – 6
0.4
/ II
2 609 007 302 | (11.7.13)