Storage; Jet Pump Cleaning; Fuel System Protection; Engine Oil And Filter Replacement - Sea-doo 210 Challenger Series Operator's Manual

STORAGE

It is recommended that the boat be
taken to an authorized Sea-Doo Sport
Boats dealer for proper storage but the
following operations can be performed
by you with a minimum of tools.
NOTE: Leave drain plug out during
storage period.
NOTICE
Do not run the engines
during the storage period.

Jet Pump Cleaning

Clean jet pump by spraying water in its
inlet and outlet and then apply a coat-
ing of XPS LUBE (P/N 293 600 016) or
equivalent.
WARNING
Always remove safety lanyard
from emergency
switch to prevent unexpected en-
gine starting before cleaning the
jet pump area. Engine must not be
running for this operation.

Fuel System Protection

BRP FUEL STABILIZER (P/N 413 408
600) (or equivalent), can be added in
fuel tank to prevent fuel deterioration
and fuel system gumming. Follow sta-
bilizer manufacturer's instructions for
proper use.
NOTICE
It is highly recommended
to add fuel stabilizer at storage in or-
der to maintain fuel system in good
condition.
Engine Oil and Filter
Replacement
The oil change and filter should be
performed by an authorized Sea-Doo
Sport Boats dealer.

Exhaust System Flushing

Perform procedure as described in
MAINTENANCE
______________
108
engine
section.
Engine Internal
Lubrication
NOTE: Both engines must be inter-
nally lubricated for the storage period.
1. Open the engine compartment lid.
2. Disconnect ignition coil connectors.
When disconnecting coil from
spark plug, always disconnect coil
from main harness first. Never
check for engine ignition spark
from an open coil and/or spark
plug in the engine compartment
as spark may cause fuel vapor to
ignite.
IMPORTANT: Never cut the locking
stop ties of ignition coil connectors. This
would allow mixing the wires between
cylinders.
3. Remove ignition coils.
NOTICE
coil holes before removing the spark
plugs. Otherwise, dirt would fall
into cylinder and will damage the in-
ternal components.
4. Remove spark plugs.
NOTE: After loosening the spark
plugs, a coil may be used to remove
the spark plugs. Simply bring the coil
down to spark plug and "hook" it to
then extract spark plug.
WARNING
Ensure there is no dirt in