Cd-Rom And Dvd-Rom Drives - Dell Inspiron 3500 Setup Manual

To install a Plug and Play device on a computer running Windows 98, perform the
following steps:
1. Save and exit any application programs and files you have open.
2. Shut down Windows 98.
For instructions, see the section, "Shutting Down Your Computer," in Chapter 4.
3. Turn off and unplug the computer.
4. Connect the device to the computer according to the manufacturer's instructions.
5. Plug in and turn on the computer.
When Windows 98 starts, a New Hardware Found window appears to indicate
that the device has been detected and configured.
NOTE: To install and configure a non-Plug and Play device for use with Windows 98,
access the Add New Hardware tab by clicking the Start button, pointing to Settings,
clicking Control Panel, and double-clicking the Add New Hardware icon. Follow the
instructions displayed to install the non-Plug and Play device.
&'520DQG'9'520'ULYHV
CD-ROM and DVD-ROM drives read audio CDs and a variety of other CD formats. The
DVD-ROM drive also plays DVDs.
&$87,21 'R QRW XVH WKH &'520 GULYH ZKLOH WKH FRPSXWHU LV LQ PRWLRQ
'RLQJ VR FRXOG LQWHUUXSW WKH IORZ RI GDWD EHWZHHQ WKH &'520 GULYH DQG
WKH KDUGGLVN GULYH RU GLVNHWWH GULYH
To use a disc in the drive, follow these steps:
1. Press the open/close button on the front of the drive to open the disc tray.
&$87,21 'R QRW SUHVV GRZQ RQ WKH GLVF WUD\ ZKHQ RSHQLQJ RU FORVLQJ LW
2. Place the disc in the center of the disc tray with the label side facing up.
3. Center the disc on the spindle, as shown in Figure 5-9. Then gently press the CD
or DVD down on both sides of the spindle until the disc snaps into place.
Using Computer Hardware 5-13