Installing Gas Supply - Miller MILLERMATIC 135 Owner's Manual

4-6. Installing Gas Supply

.
DO NOT use Argon/Mixed gas regulator/flowmeter
with CO shielding gas. See Parts List for optional
2
CO gas regulator/flowmeter and hose.
2
4
7
5
Tools Needed:
5/8, 1-1/8 in
OM-1324 Page 14
1
2
3
Argon Gas Or
Mixed Gas
6
Return To Table Of Contents
Obtain gas cylinder and chain to
running gear, wall, or other
stationary support so cylinder
cannot fall and break off valve.
1 Cap
2 Cylinder Valve
Remove cap, stand to side of valve,
and open valve slightly. Gas flow
blows dust and dirt from valve.
Close valve.
3 Cylinder
4 Regulator/Flowmeter
Install so face is vertical.
5 Regulator/Flowmeter Gas
Hose Connection
6 Welding Power Source Gas
Hose Connection
Connect supplied gas hose
between regulator/flowmeter gas
hose connection, and fitting on rear
of welding power source.
7 Flow Adjust
Typical flow rate is 20 cfh (cubic
feet per hour). Check wire
manufacturer's recommended flow
rate.
Ref. 802 028 / 802 441