Setting Up The Monitor; Connecting The Stand; Connecting Your Monitor - Dell SE2416H User Manual

Setting up the monitor

Connecting the stand

NOTE: The stand is detached when the monitor is shipped from the factory.
To attach the monitor stand:
1. Place the monitor on a soft cloth or cushion.
2. Insert the tabs on the upper part of the stand in to the grooves on the back of
the monitor.
3. Press down the stand till it snaps into place.

Connecting your monitor

WARNING: Before you begin any of the procedures in this section, follow the
Safety Instructions.
NOTE: Do not connect all cables to the computer at the same time. It is
recommend to route the cables through the cable-management slot before you
connect them to the monitor.
To connect your monitor to the computer:
1. Turn Off your computer and disconnect the power cable.
Connect the VGA/HDMI cable from your monitor to the computer.
2
3
Setting up the monitor
11
|