Programming The Immobilizer System - PIAGGIO beverly 500 User Manual

new storage procedure are deleted from the memory. Any lost keys will therefore not
be enabled to start the engine.
WARNING
EACH KEY HAS ITS OWN AND UNIQUE CODE, WHICH MUST BE STORED BY
THE SYSTEM CONTROL UNIT.
VIOLENT SHOCKS MAY AFFECT THE ELECTRONIC COMPONENTS OF THE
KEY.
IF OWNERSHIP OF THE VEHICLE IS TRANSFERRED, THE RED-HANDGRIP KEY
(AS WELL AS THE OTHER KEYS) AND THE "CODE CARD" MUST ALSO BE
TRANSFERRED TO THE NEW OWNER.

Programming the immobilizer system

The procedure for programming the «PIAGGIO IMMOBILIZER» system and/or for
storing other key codes is described below.
The programming procedure should be carried out with the engine stop switch set to
«RUN».
Procedure start - red key
Insert the red-handgrip key in the switch key (in "OFF" position) and turn it to "ON".
After 1 - 3 seconds, turn the key to "OFF" again and pull it out.
Intermediate step - black key
After pulling out the red key, insert the black key within 10 seconds and promptly turn
it to "ON". After 1-3 seconds, turn the key to "OFF" again and pull it out. In this way,
a maximum of 7 black keys can be programmed by repeating the above procedure
keeping the indicated times.
14