Advertisement
Getting Started
When assembling your steam mop there may be a little
water in or around the water tank. This is because we
test all our steam mops 100% before you buy them, so
you get a quality Shark
®
Light & Easy
™
Steam Mop.
a
c
b
b
e
d
FIRST THINGS FIRST, YOU NEED TO KNOW
WHAT'S IN THE BOX YOU JUST OPENED:
a
Upper Extension Tube
b
Lower Extension Tube (Telescopic)
c
Steam Mop Base
d
2 All-Purpose Cleaning Pads
e
Filling Flask
5
www.sharkclean.eu
fig. 1
ASSEMBLY
1
Remove all the parts from the package. Verify all the
listed parts are included.
2
Slide the upper extension tube (the tube with the
handle) into the lower extension tube (the short
tube). Push the two extension tubes together in until
you hear it click into place. (fig. 1)
fig. 2
3
Insert the assembled handle piece into the steam
mop base. Push the tube base together until you
hear a click. (fig. 2)
4
For your comfort, you can adjust the height of the
mop. Just lift the latch on the tube 90 degrees to the
open position. Holding the handle, extend the tube
to the desired height and then close the latch to the
locked position. (fig. 3)
QUICK TIP: For easier pushing and pulling, extend
the handle length.
fig. 3
IMPORTANT: Never use the Light & Easy
™
Steam Mop without attaching a microfibre
cleaning pad to avoid damage to your floor and
mop.
IMPORTANT: Do not use on unsealed wood
or unglazed ceramic floors. On surfaces that
have been treated with wax or some no wax
floors, the sheen may be removed by the heat
and steam action. It is always recommended
to test an isolated area of the surface to be
cleaned before proceeding. We recommend
that you check the use and care instructions
from the floor manufacturer.
www.sharkclean.eu
6
Advertisement
