Advertisement
Care of Your Light & Easy
Steam Mop
™
fig. 12
40°
CARE OF YOUR MICROFIBRE CLEANING
PADS
1
We recommend washing your microfibre cleaning
pads separately from other fabrics to avoid picking
up lint. Only use liquid detergent (no powder
detergent). Don't use any fabric softeners or bleach.
Line dry. Do not tumble dry. (fig. 12)
11
www.sharkclean.eu
fig. 13
2
If there are loose threads on the microfibre cleaning
pad carefully cut the thread with scissors. Don't pull
on them or cut at the base. (fig. 13)
IMPORTANT: The microfibre cleaning pad may
be very hot from the steam. Use caution when
removing. Let the unit cool for 2-3 minutes.
Trouble Shooting
PROBLEM
POSSIBLE REASONS & SOLUTIONS
Your steam mop should be securely plugged into an electrical outlet only.
The Light & Easy
Steam Mop
™
will not turn-on.
Check your fuse or breaker.
Light & Easy
Steam Mop will
™
Is there water in the water tank? If not, add water to your steam mop following
not make steam.
instructions on page 7.
Check to see if your cleaning pad is too wet. We recommend you unplug the
Light & Easy
™
Steam Mop
steam mop and change the cleaning pad.
leaves water on the floor.
Make sure the cleaning pad is attached correctly.
Do not leave your steam mop on the floor with a damp or wet cleaning pad.
Light & Easy
Steam Mop left
™
If you're using tap water, we recommend switching to distilled water.
white spot on the floor.
Make sure the cap is secured on the water tank.
The cleaning pad might be dirty. Change the cleaning pad.
If you washed the cleaning pad with powder detergent, then your pad could be
damaged and require replacement.
This could also be an indication of prior soap or grease residue that has
accumulated on the floor. As our steam mops use only a small amount of
Floors are cloudy, streaky or
water, it may not be wet enough to rinse off the accumulation that the steam
spotty after steaming.
is bringing to the surface. We suggest rinsing the floor with nothing but water,
letting it dry, and then steam mopping again with a clean pad. One or more
rinses generally removes the residue.
A more stubborn case may require you to rinse the floor with a mix of one part
vinegar and two parts water.
Make sure the steam pad is attached correctly.
Light & Easy
Steam Mop is
™
Check to see if the cleaning pad is excessively dirty. Replace if the pad is too
hard to push.
dirty or wet.
12
www.sharkclean.eu
Advertisement
