Advertisement
Using Your Light & Easy
Steam Mop - cont.
™
2
Wait 30 seconds for the boiler to heat the water.
Pump the handle a few times to prime the pump,
activate steam and moisten the microfibre pad.
(fig. 8)
9
www.sharkclean.eu
If your Light & Easy
Steam Mop stops
™
steaming, it could be out of water. Unplug the
power cord from the electrical outlet and refill
the water tank at anytime.
fig. 8
fig. 9
3
Mop with a forward and backward motion to
customize steam output automatically. (fig. 9)
IMPORTANT: Never leave the Light & Easy
Steam Mop with a damp/wet microfibre pad
on any floor surface for any amount of time as
this may damage the floor.
Care of Your Light & Easy
AFTER USE AND STORAGE
1
When you have finished using the Light & Easy
™
Steam Mop, unplug the cord from the outlet and
place the mop into the upright position and let the
unit cool 3-5 minutes. Release steam by pumping
the handle several times.
2
Carefully separate microfibre cleaning pad from
steam mop, avoiding contact with the hot pad or
dirt. (fig. 10)
3
Empty the water tank before storage. Remove the
water tank cap and empty the tank over a sink.
Replace the water cap.
Steam Mop
™
fig. 10
4
To store the cooled Shark
Mop, hang on a large hook. (fig. 11)
™
NOTE: If you want to store the Light & Easy
Mop standing upright, make sure it is leaning
against a wall for added support and safety. Always
store your Shark
®
Light & Easy
the microfibre cleaning pad removed. Store away
from children and high traffic areas.
www.sharkclean.eu
fig. 11
Light & Easy
Steam
®
™
™
Steam
™
Steam Mop with
10
Advertisement
