8
STEP1 Getting started
2 Parts Description
Main Printing Unit
Front
DK Roll compartment cover
3 Setting the DK Roll
1
Press and hold the ON/OFF button to turn
the QL-1060N off. Pull up the left and right
levers on the machine under the top cover,
and open the cover.
2
Put the spool into the spool guides in the DK
Roll compartment.
Make sure that the spool arms are inserted firmly in
•
the spool guides on the left and right.
Insert the spool with the DK Roll located on the right
•
hand side of the QL-1060N.
3
Thread the end of the DK Roll into
the slot until it aligns with the roller.
When unable to thread the end of the
DK Roll into the slot, thread it as far as
possible, and then close the cover.
Press the ON/OFF button to turn the
QL-1060N on, and then press the
FEED button to set the roll.
Rear
LED lamp
ON/OFF button
CUT button
FEED button
Serial port
USB port
LAN port
Power cord