For Network Interface Users (Dcp-540Cn Only); (For Mac Os ® X 10.2.4 Or Greater) - Brother DCP-330C Quick Setup Manual

Installing the Driver & Software

For Network Interface Users (DCP-540CN only)

(For Mac OS
Important
Make sure that you have finished the
instructions from Step 1 Setting Up the
Machine on pages 4-11.
1
Using both hands, use the plastic tabs on both
sides of the machine to lift the scanner cover
until it locks securely into the open position.
2
Connect the network cable to the LAN socket
marked with a
LAN socket inside the machine on the left as
shown below.
3
Carefully guide the network cable to the trench
as shown below, following the trench around
and toward the back of the machine.
Then, connect the cable to your network.
®
X 10.2.4 or greater)
symbol. You will find the
Improper Setup
Make sure that the cable does not restrict the
cover from closing, or an error may occur.
Note
If both USB and LAN cables are being used, guide
both cables through the trench with one on top of
the other.
4
Lift the scanner cover to release the lock (
Gently push the scanner cover support down
( ) and close the scanner cover (
Note
Make sure that the machine is turned on by
connecting the power cord.
5
Turn on your Macintosh
6
Put the supplied CD-ROM into your CD-ROM
drive.
Macintosh
).
).
®
.
23
®