Honda Goldwing GL1800/A Owner's Manual page 145

Final Drive Oil
Changing Oil
Refer to
RIGHT REAR
Change the oil with the final drive at normal operating temperature to assure
complete and rapid draining.
1. Place the motorcycle on its center stand on a firm, level surface.
2. Place a drain pan under the drain bolt.
3. Remove the oil filler cap and the drain bolt.
4. After the oil has completely drained, check that the sealing washer is in good
condition. Reinstall the drain bolt with its sealing washer (or a new washer, if
necessary) and tighten it to the specified torque:
14 lbf·ft (20 N·m , 2.0 kgf·m)
5. Fill the final drive with the recommended oil:
4.1 US oz (120 cm )
Make sure the final drive oil level is at the lower edge of the oil filler
inspection hole.
6. Install the oil filler cap.
138
Downloaded from www.Manualslib.com
Saf ety Precautions on page
Servicing Your Honda
manuals search engine
106 .
oil filler cap
drain bolt
lower edge