Draining The Bilge Water; Draining The Bilge Water On Land - Yamaha WaveRunner FZR 2012 Owner's/Operator's Manual

(6) Loosen the engine oil filler cap and re-
move it.
1 Engine oil filler cap
(7) Slowly add engine oil.
TIP:
The difference between the minimum and
maximum level marks on the dipstick is equal
to approximately 1 L (1.06 US qt, 0.88 Imp. qt)
of engine oil.
(8) Wait approximately 5 minutes to allow the
engine oil to settle, and then check the
engine oil level again.
(9) Repeat steps 3–8 until the engine oil is at
the proper level.
(10) Securely install the engine oil filler cap by
tightening it until it stops.
(11) Securely install the seats in their original
positions.
Operation and handling requirements
1
EJU40021

Draining the bilge water

ECJ01301
NOTICE
Do not run the engine at full throttle when
bilge water remains in the engine compart-
ment. The bilge water can splash into the
engine, which can result in severe dam-
age.
EJU40033

Draining the bilge water on land

To drain the bilge water on land:
(1) Loosen the stern drain plugs and remove
them.
1
1 Stern drain plug
(2) Raise the bow of the watercraft, such as
by placing the watercraft on a slope, to
drain the bilge water from the engine
compartment.
(3) After the bilge water has drained from the
stern drain plug holes, wipe up any re-
50