Draining The Bilge Water On Water - Yamaha 210FSH SPORT 2020 Operator's Manual

(2) Remove the fuel tank compartment drain
plug to drain the water.
1 Fuel tank compartment drain plug
(3) If the boat was operated in salt water,
wash down the compartment with fresh
water.
(4) Securely install the drain plug in its origi-
nal position.
(5) Close the engine hood.
Draining the bilge water from the hull
Remove the hull drain plug at the stern to
drain the water. Check the condition of the
O-ring on the hull drain plug, and then se-
curely install the drain plug.
1 Hull drain plug
Operation and handling requirements
1
1

Draining the bilge water on water

This model is equipped with a self-draining
deck and bilge pump to drain the bilge water
on water.
Self-draining deck
Most water that enters the deck area drains
automatically out the stern through the large
drain holes in the deck.
A one-way check valve in each drain pre-
vents water from traveling back to the deck
while the boat is moored or moving in re-
verse.
Bilge pump
Your boat is equipped with a drainage sys-
tem that channels water that enters the boat
from the storage compartments to the bilge
under the engine compartment.
When the bilge pump switch is turned on, the
bilge pump will operate.
1 Bilge pump switch
Even if the bilge pump switch is not turned
on, the bilge pump will detect when there is
excessive water in the bilge and will automat-
ically drain most of it through the bilge pump
outlet. This function works automatically,
even if the battery switches are turned to the
off position.
LIVEWELL BILGE HORN
1
82