Installing the Coin-Cell Battery
1.
Place the coin-cell battery on the system board until it snaps in place.
2.
Install the:
•
bezel
•
cover
3.
Follow the procedures in
Removing the Heatsink Module
1.
Follow the procedures in
2.
Remove the:
•
cover
•
bezel
3.
Open the
front-bezel
4.
Perform the following steps to remove the heatsink module from the computer:
a. Disconnect the heatsink-module cable from the connector on the system board [1].
b. Remove the captive screws that secure the heatsink module to the system board [2, 3, 4, 5].
c. Lift to remove the heatsink module from the computer [6].
Installing the Heatsink Module
1.
Place the heatsink module on the processor.
2.
Tighten the captive screws to secure the heatsink module to the system board.
3.
Connect the heatsink-module cable to the connector on the system board.
4.
Close the front-bezel door.
5.
Install the:
•
bezel
•
cover
6.
Follow the procedures in
18
After Working Inside Your
Before Working Inside Your
door.
After Working Inside Your
Computer.
Computer.
Computer.