Common - Sony DRC-BT60 Operating Instructions Manual

Troubleshooting
If you run into any problems using the unit, use the following checklist and read
the product support information on our website.
Should any problem persist, consult your nearest Sony dealer.

Common

The unit is not turned on.
 Charge the battery of the unit.
 The unit cannot be turned on while
charging. Remove the USB cable from
the unit, and then turn on the power.
Pairing cannot be done.
 Bring the unit and the Bluetooth device
closer together.
Cannot make the Bluetooth
connection.
 Check that the unit is turned on.
 Check that the Bluetooth connecting
device is turned on and the Bluetooth
function is on.
 Connection with the Bluetooth device
may not be memorised on the unit.
Make the Bluetooth connection from the
Bluetooth device to the unit soon after
pairing is complete.
 The unit or Bluetooth connecting device
is in sleep mode.
 The Bluetooth connection is terminated.
Make the Bluetooth connection again
(when listening to music: see page 17,
when calling: see page 20).
Distorted sound
 Ensure that the unit is not receiving
interference from a wireless LAN, other
2.4 GHz wireless device, or microwave
oven.
The correspondence distance
is short. (Sound skips.)
 If a device that generates
electromagnetic radiation, such as a
wireless LAN, other Bluetooth device(s),
or a microwave oven is nearby, move
away from such sources.
 Point the aerial of the unit towards the
Bluetooth device (page 33). Make sure
no obstacles block the communication.
The unit does not operate
properly.
 Reset the unit. Pairing information is
not deleted by this operation.
Insert a small pin, etc., into the hole, and
push until you feel a click.
5
GB