Calling - Sony DRC-BT60 Operating Instructions Manual

Calling

VOL+/− button
/
button
Check the following before operating
the unit.
– The Bluetooth function is active on
the mobile phone.
– Pairing of the unit and the Bluetooth
mobile phone is complete.
1
Press and hold the POWER
button for about  seconds
while the unit is turned off.
"Power On" appears on the display
as the indicator (blue) flashes
twice, and then the unit turns on.
The unit tries to connect to the last
Bluetooth mobile phone that was
used.
Tip
The unit will stop trying to connect to
the Bluetooth mobile phone after 1
minute. In such a case, press the
button to try to connect again.
0
GB
When the unit does not
connect to a Bluetooth mobile
phone automatically
POWER
You can make a connection by
button
operating Bluetooth mobile phone or
by operating the unit to connect the
last connected Bluetooth device.
 To make a connection by
button

1
button
operating Bluetooth mobile
phone
Make the Bluetooth connection
(HFP or HSP*) from the Bluetooth
mobile phone to the unit.
Refer to the manual supplied with
your Bluetooth mobile phone for
operation details.
The list of recognised devices
appears on the display of the
Bluetooth mobile phone. The unit
is displayed as "DRC-BT60."
When you use the Bluetooth
mobile phone features both HFP
and HSP, set to HFP.
Note
When connecting to a Bluetooth mobile
phone which is different from the last
connected one, make the connection
following the above procedure.
* For details on profiles, see page 4.