Lutron Electronics TM-947SD Operation Manual page 13

5-2 Auto Datalogger ( Set sampling time
a. Start the datalogger
Press the " REC Button ( 3-4, Fig. 1 ) once , the LCD will
show the text " REC ", then press the " Logger Button "
( 3-8, Fig. 1 ), the " REC " will flashing and beeper will
sound, at the same time the measuring data along the
time information will be saved into the memory circuit.
Remark :
How to set the sampling time, refer to Chapter 7-6,
*
page 19.
How to set the beeper sound is enable, refer to
*
Chapter 7-4, page 18.
b. Pause the datalogger
During execute the Datalogger function , if press the
" Logger Button " ( 3-8, Fig. 1 ) once will pause the
Datalogger function ( stop to save the measuring data
into the memory circuit temporally ). In the same time
the text of " REC " will stop flashing.
Remark :
If press the " Logger Button " ( 3-8, Fig. 1 ) once again
will execute the Datalogger again, the text of " REC " will
flashing .
c.. Finish the Datalogger
During pause the Datalogger, press the " REC Button "
( 3-4, Fig. 1) continuously at least two seconds, the " REC "
indicator will be disappeared and finish the Datalogger.
11
1 second )
≧