Print Quality Check - Brother DCP-110C Quick Setup Manual

Step 1

Print Quality Check

7
1
After the cleaning cycle is finished, the LCD
shows:
Set Paper and
Press Start
2
Make sure the paper is loaded in the paper
tray.
Press Colour Start.
3
The machine starts printing the PRINT
QUALITY CHECK SHEET (only during
initial ink cartridge installation).
Print Quality Check
1. Check the quality of the four-color blocks formed by the short lines.
2. If all the short lines are clear and visible, the quality is acceptable. the quality is acceptable.
Select (Yes). If you can see missing short lines, select (No) to begin the color cleaning process
and follow the prompts on the LCD.
Avoid touching the printed surface
of the paper immediately after
printing, the surface may not be
completely dry and may stain your
fingers.
4
The LCD shows:
Is Quality OK?
▲ Yes ▼ No
Check the quality of the four colour blocks
formed by the short lines printed on the
sheet.
(BLACK/ CYAN/ YELLOW/ MAGENTA)
8
Setting Up the Machine
5
If all lines are clear and visible, press
finish the quality check.
---OR---
If you can see missing short lines, press
6
and go to .
OK
6
The LCD asks you if the print quality is OK
for black and colour. Press
control panel.
Black OK?
▲ Yes ▼ No
After making your selection
(No) for black and colour, the LCD shows:
Start Cleaning?
▲ Yes ▼ No
▲
Press (Yes), the machine will then start
cleaning the colours.
After cleaning is finished, press
Colour Start. The machine starts printing
the PRINT QUALITY CHECK SHEET again
and goes back to step
▲
to
▼
Poor
▲ ▼
or on the
▲ ▼
(Yes) or
3
.