Table of Contents
Advertisement
Drain system
• Never forget to install drain hose before operating your washer.
• Open the packing box, and the drain hose is tied at backside of washer.
• If you use the laundry tub, Top of laundry tub must be at least 60cm high and no higher than
100cm from bottom of washer.
ca. 105 cm
• When installing the drain hose to tub(sink), secure it tightly with a string.
• Proper securing of the drain hose will protect the floor from damage due to water leakage.
• When the drain hose is too long, do not force it back into the washer.
This will cause abnormal noise.
Level adjustment
1 If the washer is installed on an
unsuitable floor, it could make
considerable noise, vibrate and
cause a malfunction.
2 Adjust the level of washer using adjustable legs.
• Please check if there is any gap between the
four adjustable legs and the floor.
• Adjust the level of washer by turning
adjustable legs. And make it sure that there is
no swaying of washer.
• After the adjustment is finished, turn the fixing
nuts up tightly so that the washer maintains
the adjustment.
3 Make it sure that the washer does not sway when you press
down the four corners of the washer's top plate.
NOTE
There should be no swaying of washer and all the
adjustable legs should stick to the floor closely.
Laundry tub
Hose
Retainer
max. 100 cm
min. 60cm
adjustable leg
5
Tie
max. 100 cm
strap
min. 60cm
Fixing Nut
Advertisement
Table of Contents
