Install The Battery; Charge The Battery; Turn On The Camera - HP Photosmart R830 Series User Manual

Chapter 1

Install the battery

1. Open the Battery/Memory Card door by sliding
the door latch as indicated on the Battery/
Memory Card door.
2. Insert the battery in the larger slot, pushing the
battery in until the latch catches.
3. Close the Battery/Memory Card door.
To remove the battery, move the battery latch as
shown until the battery springs free.
NOTE:
the first time (see
on page
removing the battery.

Charge the battery

To charge the battery in the camera:
1. Plug the small end of the USB
cable into the camera and the large
end into the power adapter, then
plug the power adapter into an
electrical outlet, as shown.
It may take up to one minute for the
camera's Battery Charging light to
start blinking, indicating that the
battery is charging. The battery is
fully charged when the Battery
Charging light turns on solid (see
on page 49
2. When charging is complete, disconnect the camera from the power adapter.
NOTE:
Ion battery" on page

Turn on the camera

To turn on the camera, slide the lens cover open until
it clicks, uncovering the lens.
To turn off the camera, slide the lens cover closed
until it clicks, covering the lens.
CAUTION:
your fingers clear of the lens. Fingerprints on the
lens can impair the quality of the picture.
6 Getting started
Fully charge the battery before using it
"Charge the battery"
6). Turn off the camera before
for information on charging times).
For other methods for recharging the battery, see
49.
When sliding the lens cover, keep
"Recharging the Lithium Ion battery"
"Recharging the Lithium