Setting Up Your Camera Charge The Battery; Install The Battery - HP Photosmart R740 series Quick Start Manual

2 Setting up your camera
Charge the battery
Before using the battery for the first time, fully charge it
using the charger that came with your camera.
NOTE:
Your camera uses a rechargeable
HP Photosmart LI40 battery (Q6277A). Do not charge
any other battery in the charger.
1. Plug the charger into an
electrical outlet, then insert the
battery into the charger as
shown.
The charger's Battery Charging
light is orange while the battery
is charging; the battery is fully
charged when the light turns
green (approximately 1.5
hours).
2. Remove the battery from the
charger once it is fully charged.

Install the battery

1. Open the Battery/Memory Card door by
sliding the door latch as indicated on the
Battery/Memory Card door.
2. Insert the battery in the larger slot,
pushing the battery in until the latch
catches.
3. Close the Battery/Memory Card door.
8 HP Photosmart R740 series Digital Camera