Wiring Diagram-Wfd195 - Whirlpool WGFM195 Installation Instructions Manual

3. For most jobs, about 400 CFM per ton when cooling is
desirable.
4. Installation is to be adjusted to obtain temperature rise within
the range specified on the rating plate.
5. The chart is for information only. For satisfactory operation,
external static pressure must not exceed value shown on
rating plate. The shaded area indicates ranges in excess of
Disconnect ALL power before servicing.
Multiple power sources may be present.
Failure to do so may cause property damage, personal injury or death.
Equipment GND
Field GND
Field Splice
Switch (Temp.)
Igniter
Pressure Switch
Overcurrent
Prot. Device
Low Voltage (24V)
Low Voltage Field
High Voltage (115V)
High Voltage Field
Junction
Terminal
Internal To
Integrated Control
Plug Connection
Color Symbol
Gray
White
Black
Red
Blue
Orange
Yellow
Green
Pink
Azure
Violet
Brown
Steady On = Normal Operation
Off = Control Failure
1 Flash = System Lockout (Retries Exceeded)
2 Flashes = Pressure Switch Stuck Closed
3 Flashes = Pressure Switch Stuck Open
4 Flashes = Open High Limit Switch
5 Flashes = Flame Sense without Gas Control Valve
6 Flashes = Open Rollout Limit Switch or Open Fuse
7 Flashes = Low Flame Signal
8 Flashes = Check Igniter or Improper Grounding
Continuous/
Rapid Flashes = Reversed 115 VAC Polarity
Wiring is subject to change.
Always refer to the wiring
diagram on the unit for the
most up-to-date wiring.
Check codes for proper wiring and circuit protection before installation.
44
WIRING DIAGRAM—WFD195
ON OFF
GY
W
BK
R
BU
OR
Y
G
PK
A
V
BR
Auto Reset
Primary Limit
Control
Induced Draft
Blower Pressure
Humidifier
Switch
12-Circuit
Connector
Hot
Surface
Igniter
maximum external static pressure allowed when heating. The
data for 0.6" W.C. to 0.8" W.C. is shown for air conditioning
purposes only.
6. The above chart is for U.S. furnaces installed at 0 to 2,000 ft
(609.6 m). At higher altitudes, a properly de-rated unit will
have approximately the same temperature rise at a particular
CFM, while the ESP at that CFM will be lower.
WARNING
HIGH VOLTAGE!
Y
2nd
Stage
*
Delay
Mode
*
Heat
Off
*
Delay
FS
Manual Reset Rollout Limit (Control(s)
(Single Control On 45k Btu)
Front Cover
Pressure Switch
1
2
3
Gas Control Valve
COOL-H