Operating Instructions - Worx WU022 Manual

OPERATING INSTRUCTIONS

1. CHARGING YOUR BATTERY PACK
Warning:The Charger and battery
pack are specifically designed to work
together so do not attempt to use any other
devices. Never insert or allow metallic objects
into your charger or battery pack connections,
because an electrical failure and hazard will
occur.
2. BEFORE USING YOUR LIGHT
Your battery pack is UNCHARGED and you
must charge once before use.Your battery
pack will not be fully charged until you have
performed several charge and discharge
operations by charging & working with
your flashlight. After this your battery pack
performance will improve.
3. HOW TO CHARGE YOUR BATTERY
Charging procedure
1)Plug the charger into an appropriate outlet.
The red light (8) will flash for 1 second and
then go out.
2)Insert the battery pack into the charger ,
the red light (8) will stay on to indicate the
charging process has started.
08
3)On completion of charge the red light (8) will
change to continuous green.The pack is now
fully charged ,unplug the charger and remove
the battery pack
Charging indicator
This charger is designed to detect some
problems that can arise with battery packs.
Indicator lights indicate problems (see table
below). If this occurs, insert a new battery pack
to determine if the charger is OK. If the new
battery charges correctly, then the original
pack is defective and should be returned to a
service center or recycling service center. If the
new battery pack displays the same problem
as the original Battery Pack, have the charger
tested at an authorized service center.
Worklight
13L-WU022-M-060905.indd 8
ON/OFF
Light
flash
Red on
Red slow
- - - - -
flash
Red fast
-------------
flash
Green on
Green slow
- - - - -
flash
Green fast
-------------
flash
Hot/cold battery pack delay
This charger has a HOT/COLD battery pack
delay feature. When the charger detects
a battery pack that is too hot or cold (the
green light will flash slowly), it automatically
starts a HOT/COLD Pack Delay, and suspends
charging until the battery pack has reached
the correct temperature.The charging process
will then automatically begin (red light ON
continuously).This feature ensures maximum
battery life.
Leaving the battery pack in the charger
If a fully charged battery pack is left in the
charger, the green light (9) will remain ON.
The battery pack will remain charging with a
current of about 150mA.
Note: A battery pack will slowly lose its
charge when kept out of the charger or left
in an unplugged charger. It may need to be
recharged before use.
Weak battery packs
This charger will detect a weak battery pack.
When a weak battery pack is inserted into the
charger, the charger will try to repair it.This
process will last about 30mins (the green light
will flash slowly). When the repair is finished,
it will automatically begin to charge the battery
pack to the highest capacity possible (the red
light stays ON). If the green light (9) flashes for
more than 30mins, the red light (a) will begin
to flash slowly indicating the battery pack is
dead.
Note: Repaired battery packs are still usable
but should not be expected to perform as
Status
Charging
Dead battery
Battery failure or
charger invalidated
Charging complete
Hot/Cold delay; weak
battery repair; battery
abnormal
Charging battery too
hot
ENG
2006-9-13 10:50:38