Maintenance; Environmental Protection - Worx WU022 Manual

properly.This battery pack contains Ni-Mh/
Ni-Cd batteries. Consult your local waste
authority for information regarding available
recycling and/or disposal options. Discharge
your battery pack by operating your light, then
remove the battery pack from the light housing
and cover the battery pack connections with
heavy duty adhesive tape to prevent short
circuit and energy discharge. Do not attempt to
open or remove any of the components.
WORKING HINTS FOR YOUR
WORKING LIGHT
1. THE BULB IS DIM OR NOT WORKING
WHEN I TURN ON THE SWITCH, WHY?
If the battery is not fully charged, recharge
the battery with the supplied battery charger
(Note: Do not charge the battery with a
different charger. Charge the battery pack only
with the charger provided).
Also check if the bulb you used is correct, if
not, replace it with a correct one following the
instructions in this manual.
Warning: The bulb become hot when
used, it could be hurt your finger.
Turn off the switch let your flashlight
10
cool for several minutes and ensure the
bulb becomes cool before you check the
bulb.
2. I CANNOT FIT THE BATTERY INTO THE
BATTERY CHARGER. WHY?
The battery can be inserted into the charger
only in one direction.Turn the battery around
until it can be inserted into the slot, the red
LED light should turn on when the battery is
charging (See F .1 and F .2).
3. REASONS FOR DIFFERENT CHARGING
TIMES.
Your charge time can be affected by many
reasons, which are not defects in your product.
If the battery pack is only partly discharged
it may be re-charged in less than 1 hour. If
the battery pack and ambient temperature
are very cold then re-charging may take 1-1.5
hours. If the battery pack is very hot it will not
re-charge because the internal temperature
Worklight
13L-WU022-M-060905.indd 10
safety cutout will prevent it. If the green light
(9) is illuminated but the red light (8) will not
illuminate and the battery pack is hot then
this will be the problem and NOT a defect.
You must remove your battery pack from the
charger and allow your battery pack to cool
first to ambient temperature and then re-
charging can be started. If you charge a second
battery pack immediately after the first then
the charger can be overheated. Always allow
at least 15 minutes rest between battery pack
charging.
4. REASONS FOR DIFFERENT BATTERY
PACK WORKING TIMES
Charging time problems, as above, and
having not used a battery pack for a prolonged
storage will reduce the battery pack working
time.This can be corrected after several charge
and discharge operations by charging &
working with your flashlight. Do not re-charge
your battery pack below 0ºC and above 30ºC as
this will affect performance.

MAINTENANCE

Your tool requires no additional lubrication or
maintenance.There are no user serviceable
parts in your tool, battery pack or changer.
Never use water or chemical cleaners to clean
your tool. Wipe clean with a dry cloth. Always
store your tool in a dry place. Keep the motor
ventilation slots clean. If you see some sparks
flashing in the ventilation slots, this is normal
and will not damage your tool.
ENVIRONMENTAL
PROTECTION
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your Local Authority or retailer for
recycling advice.
ENG
2006-9-13 10:50:39