Table of Contents
Advertisement
USE
WARNING!
On some points of the machine there are
some adhesive plates indicating:
– DANGER
– WARNING
– CAUTION
– NOTE
While reading this Manual, the Operator must pay
particular attention to these symbols.
Do not cover these plates for any reason and immediately
replace them if they are damaged.
BATTERY CHECK/SETTING ON A NEW
MACHINE
The machine requires one 24V battery, or four 6V
batteries in serial connection.
The machine can be supplied in one of the following
modes:
a)
Batteries already installed and ready to be used.
1. Lift the hood (13, Fig. C) and secure it with the rod
(16, Fig. V).
Check that the batteries are connected to the
machine through the related connector (4, Fig. V).
2. Disengage the support rod an lower the hood and
ensure that it is correctly closed.
3. Insert the ignition key (18, Fig. B) in the control
panel and turn it to "I" position (without activating
the forward/reverse gear pedal 20, Fig. B).
If the green warning light (9, Fig. B) turns on, the
battery is ready to be used.
If the yellow or red warning light (8 or 7, Fig. B)
turns on, it is necessary to charge the battery (see
procedure in Maintenance chapter).
146 2601 000(1)2005-03 A
USER MANUAL
b)
Batteries installed on the machine but dry, that is
without electrolyte.
1. Lift the hood (13, Fig. C) and secure it with the rod
(16, Fig. V).
2. Remove the battery caps (3, Fig. V).
WARNING!
Be extremely careful when working with
sulphuric acid, as it is corrosive. If it comes
in contact with skin or eyes, rinse
thoroughly with water and call a physician.
Batteries have to be filled up in a properly
ventilated area. Use protective gloves.
3. Fill the cells (or each element) of the batteries with
sulphuric acid for batteries (density from 1.27 to
1.29 Kg at 25°C) in accordance with the
instructions given in the Battery User's Manual.
The correct quantity of sulphuric acid is indicated
in the Battery Manual.
Let the battery rest and fill in with sulphuric acid in
accordance with the instructions specified in the
Battery manual.
4. Charge the batteries (see the relevant procedure
in the Maintenance chapter).
c)
Without battery
1. Buy appropriate batteries (see the Technical
Characteristics paragraph).
For the battery choice and installation, apply to
qualified battery retailers.
2. Install the batteries and set the battery type (WET
or GEL) on the machine (see the following
paragraph).
3. Charge the batteries (see the relevant procedure
in the Maintenance chapter).
ENGLISH
FLOORTEC R 580 B
7
Advertisement
Table of Contents
