Summary of Contents for Nilfisk-ALTO Floortec R 360 P
Page 1
www.nilfisk-alto.com FLOORTEC R 360 P DEUTSCH BETRIEBSANLEITUNG FRANÇAIS MANUEL D’UTILISATION ENGLISH USER MANUAL NEDERLANDS GEBRUIKSAANWIJZING...
SPARE PARTS AND MAINTENANCE All necessary operating, maintenance and repair procedures must be carried out by qualified personnel or by Nilfisk-Alto Service Centers (listed at the end of this manual). Only original spare parts and accessories must be used. Call Nilfisk-Alto for service or to order spare parts and accessories, specifying the machine model and serial number.
– Do not lay any object on the engine. – Stop the petrol engine before performing any operation on it. To avoid any accidental start, disconnect the ignition spark plug cap. FLOORTEC R 360 P ENGLISH...
Service Center. – In case of part replacement, order ORIGINAL spare parts from an authorised Dealer or Retailer. FLOORTEC R 360 P – To ensure the proper and safe operation of the machine, have the scheduled maintenance, detailed...
33. Side broom height adjusting block 34. Seat longitudinal position adjusting lever 35. Manual vacuum kit (optional) 36. Petrol tank cap 37. Petrol tap and engine choke lever compartment 38. Engine exhaust pipe 39. Petrol engine ventilating grid FLOORTEC R 360 P ENGLISH...
29. Dynamo fuse 30. Engine air conveyor (See Fig. V) Petrol tap (See Fig. W) Engine choke lever FLOORTEC R 360 P TECHNICAL DATA General Machine length Machine width (without side brooms) Height (steering wheel with knob) Working width (with/without side brooms)
Main and side brooms with harder or softer bristles; – Antistatic polyester or polyester BIA C dust filter; – Manual vacuum; – Working light; – Pivoting light; – Skirts of various materials. For further information concerning the optional accessories, contact Your Retailer. FLOORTEC R 360 P ENGLISH...
(1, Fig. T). Raise the hood (10, Fig. C) and turn the petrol tap (1, Fig. V) to the ON position, then close the hood. FLOORTEC R 360 P MACHINE START AND STOP Starting the machine Sit in the driver's seat (29, Fig. C) and, if it is necessary for an easier access to the machine, pull the lever (2, Fig.
In case the quantity of oil in the carter is insufficient, the petrol engine has a warning system to prevent damages to the engine. Before the carter oil level goes below the safety limit, the oil warning system automatically stops the engine. FLOORTEC R 360 P ENGLISH...
Dump the hopper (20, Fig. C) (see previous paragraph). Engage the parking brake by rotating the lever (7, Fig. C) backward. FLOORTEC R 360 P PUSHING/TOWING THE MACHINE To easily push/tow the machine, proceed as follows: Open the hood (10, Fig. C).
Be extremely careful when performing the above-mentioned checks and always use the machine according to the indicated conditions. FLOORTEC R 360 P MAIN BROOM REPLACEMENT NOTE Brooms of various hardness are available. This procedure is applicable to all types of brooms.
(4, Fig. L) along its perimeter and check it for integrity. If necessary, replace it. 10. Reassemble in the reverse order of disassembly. NOTE Reassemble the filter with the wire gauze (2, Fig. M) facing the fan (19, Fig. U). FLOORTEC R 360 P ENGLISH...
On the machine, adjust the skirt (1, Fig. S) height by using its slots (2). – Reassemble in the reverse order of disassembly. FLOORTEC R 360 P Front and rear skirt check Remove the main broom, as described in the related paragraph.
(1): For the related procedure, see the Petrol Engine User Manual For further information, refer to the Service Manual, available at any Nilfisk-Alto Service Center. SCRAPPING Have the machine scrapped by a qualified scrapper. Before scrapping the machine, always remove the following materials: –...