Mitsubishi PKA-RP60KAL.TH Servise Manual page 29

(2) Setting method of each function by wired remote controller
A
D
4
5
1. Stop operation(1).
2. Press the button (2) for 3 seconds so that [Maintenance mode] appears on the screen (A).
TEST
After a while, [00] appears in the refrigerant address number display area.(at B )
3. Press the button (3) for 3 seconds to switch to [Maintenance monitor].
CHECK
Note) It is not possible to switch to [Maintenance monitor] during data request in maintenance mode
(i.e., while "----" is blinking) since no buttons are operative.
[----] appears on the screen (D) when [Maintenance monitor] is activated.
(The display (D) now allows you to set a request code No.)
4. Press the [TEMP (
[ScreenB]
00
5. Press the [CLOCK (
6. Press the button (6) to perform function setting.
FILTER
If above setting operations are done correctly, "Request code number will appear in data display area.(C)
[Example: When the "311" of "Request code number" is set, [311] appears on the screen.(C)]
[Refererence]
You can check current "request code number" setting by setting the "request code number"("310" or "320") and
pressing the button.(6)
FILTER
[Example: When the current setting is "Setting No.2(Request code 311)", [311] appears on the screen.(C)]
7. To return to normal mode, press the
OCH452B
C
B
1
6
2
3
and )] buttons (4) to select the desired refrigerant address.
01
and )] buttons (5) to set the desired request code No.("311–318", "321–324")
button (1).
[ON/OFF
29
B: Refrigerant address
C: Data display area
D: Request code display area
15