Care And Maintenance - HAMPTON BAY PG171H-B Use And Care Manual

Care and Maintenance

□ Abrasive cleaners will damage this product.
□ Never use oven cleaner to clean any part of the heater.
□ Do not clean any heater part in a self-cleaning oven. The extreme heat will damage the finish.
□ More frequent cleaning may be required as necessary. It is imperative that the control compartment, burners and
circulating air passageways of the heater be kept clean.
□ Spiders and insects can create a dangerous condition that may damage the heater or make it unsafe. Keep the
burner area clean of all spiders, webs or insects. Clean burner holes by using a heavy-duty pipe cleaner.
Compressed air may help clear away smaller particles.
□ Inspect the heater before each use.
□ Have the heater inspected annually and ensure repairs are made by a qualified service person.
□ Check the heater immediately if any of the following conditions exist:
a. The smell of gas in conjunction with extreme yellow tipping of burner flames.
b. The heater does not reach proper temperature.
c. The heater's glow is excessively uneven.
d. The burner makes popping noises during use. This is normal when extinguishing the burner.
□ Carbon deposits may create a fire hazard. Keep the dome and emitter clean at all times.
□ Do not clean the heater with combustible or corrosive cleaners. Use warm, soapy water.
□ Do not paint the engine, engine access panel or dome.
□ This heater should be thoroughly cleaned on a regular basis.
□ After a period of storage and/or non use, check for leaks, burner obstructions and inspect for any abrasion, wear,
cuts to the hose.
CLEANING
□ Wipe surfaces clean with mild dish detergent or baking soda.
□ For stubborn surfaces use a citrus-based degreaser and a nylon scrubbing brush.
□ Rinse clean with water.
NOTE:
1. While cleaning your unit, be sure to keep the area around
the burner dry at all times. Do not submerge the control valve
assembly. If the gas control is submerged in water, do NOT
use it. It must be replaced.
2. Use high-quality automobile wax to help maintain the
appearance of the heater. Apply to exterior surfaces from the
pole down. Do not apply to emitter screen or domes
MAINTENANCE
□ Keep exterior surfaces clean.
□ Air flow must be unobstructed. Keep the controls, burner and circulating air passageways clean.
□ Signs of possible blockage include:
Gas odor with extreme yellow tipping of flame.
The heater does NOT reach the desired temperature.
The heater glow is excessively uneven.
The heater makes popping noises.
NOTE:
In a salt-air environment (such as near an ocean) corrosion
occurs more quickly than normal. Frequently check for
corroded areas and repair them promptly.
14