Glass Crystals And Volcanic; Stones Installation On Burner And Firebox Floor - Regency greenfire GF900C-NG1 Owners & Installation Manual

GLASS CRYSTALS AND VOLCANIC

GLASS CRYSTALS AND VOLCANIC STONES INSTALLATION ON BURNER AND FIRE-

STONES INSTALLATION ON BURNER AND FIREBOX FLOOR

Evenly spread the Glass Crystals or optional Volcanic Stones over the burner Natural gas only. Propane do not place volcanic stones on burner assembly.
Ensure the crystals (or stones) do not overlap too much as this will effect the fl ame pattern.
IMPORTANT NOTE:
Only the supplied approved Glass Crystals and Volcanic Stones are to be used with these fi replaces. Use of any other type of glass crystals
or stones can alter the unit's performance, any damage caused by the use of any unapproved glass or stones will not be covered under warranty.
When using Stones DO NOT cover burner ports or pilot light that lead to pilot fl ame.
Ensure the crystals or stones do not overlap excessively as this will effect the fl ame pattern.
3) Work Crystals from back to front
edge of Firebox Floor
VOLCANIC STONES INSTALLATION (AROUND BURNER
Burner Ports
VOLCANIC STONES INSTALLATION (AROUND BURNER
NOTE:
Regency GF900C-1 Gas Fireplace
919-198
1) Start installing Crystals on the
4) Ensure Crystals DO NOT block the
front of the pilot hood and fl ame to
IMPORTANT: DO NOT COVER BURNER PORTS WITH VOLCANIC STONES
*
Unit is supplied with 32 volcanic stones
NOTE:
Volcanic Stones are NOT to be placed anywhere on the burner ports or Pilot assembly area.
Volcanic Stones are NOT to be placed anywhere on the burner or Pilot assembly area on Propane Units.
Ensure air gap around burner is not obstructed by the placement of the stones.
BOX FLOOR
Burner
light the burner
1
2) Distribute Crystals evenly starting
from back of Firebox Floor
NOTE: Correct fi nal glass installation of Crystals
shown in step 3 and 4
The Burner and Firebox Floor should not be visible
when the fl ame is out.
)
NG UNIT
)
PROPANE UNIT
GF900C
installation
33
10/29/12