Operation - Makita DHP480 Instruction Manual

The fastening torque can be adjusted in 16 steps by
turning the adjusting ring. Align the graduations with the
arrow on the tool body. You can get the minimum
fastening torque at 1 and maximum torque at 16.
Guideline of fastening torque
Adjusting graduations
Machine screw
Wood screw
013981
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and the
•
battery cartridge is removed before carrying out
any work on the tool.
Installing or removing the driver bit or drill bit
013967
Turn the sleeve counterclockwise to open the chuck
jaws. Place the bit in the chuck as far as it will go. Turn
the sleeve clockwise to tighten the chuck.
To remove the bit, turn the sleeve counterclockwise.
Installing the hook
2
014005
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
1 2
M4
Soft wood
(e.g. pine)
Hard wood
(e.g. lauan)
1. Sleeve
1
1. Groove
2. Hook
3. Screw
1
3
Before actual operation, drive a trial screw into your
material or a piece of duplicate material to determine
which torque level is required for a particular application.
The following shows the rough guide of the relationship
between the screw size and graduation.
4 6 8
M5
3.5 x 22
3.5 x 22
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
Installing the bit holder (Optional accessory)
1
2
013966
Fit the bit holder into the protrusion at the tool foot on
either right or left side and secure it with a screw.
When not using the driver bit, keep it in the bit holders.
Bits 45 mm-long (1-3/4") can be kept there.

OPERATION

CAUTION:
Always insert the battery cartridge all the way until
•
it locks in place. If you can see the red indicator on
the upper side of the button, it is not locked
completely. Insert it fully until the red indicator
cannot be seen. If not, it may accidentally fall out
of the tool, causing injury to you or someone
around you.
When the speed comes down extremely, reduce
•
the load or stop the tool to avoid the tool damage.
8
10 12 14
M6
4.1x 38
4.1x 38
1. Bit holder
2. Bit
16