Brother MFC-790CW Quick Setup Manual page 20

Wired Network
c
Carefully guide the network cable to the trench
as shown below, following the trench around
and toward the back of the machine. Then,
connect the cable to your network.
Note
If both USB and LAN cables are being used,
guide both cables through the trench with one on
top of the other.
Important
Make sure that the cable does not restrict the
cover from closing, or an error may occur.
d
Lift the scanner cover to release the lock a.
Gently push the scanner cover support
b and close the scanner cover c.
down
20
1
3
2
16
Connect the power cord
a
Connect the power cord.
Important
If you have previously set up your machine for
a wireless network and then want to set it up
on a wired network, you should check that the
machine's Network I/F is set to Wired LAN.
The wireless network interface will become
inactive with this setting.
On your machine, press MENU.
Press a or b to display Network and press
Network.
Press Network I/F.
Press Wired LAN.
Press Stop/Exit.
®
Windows