Table of Contents
Advertisement
o To connect the oven power cord, loosen and remove the cover
on the terminal bl
inside. Make the connection, securing the cord in place with the
cable clamp provided and then immediately close the terminal
block cover again.
o If you have to change the oven power cord, the earthing
(yellow/green) conductor must always be 10 mm longer than the
line conductors.
o Care must be taken to ensure that the temperature of the mains
supply cable does not exceed 50°C.
o If the mains supply cable is damaged, then it must be replaced
by an appropriate repla
Baumatic Spares Department.
Positioning the a
o Ensure that the aperture that you will be fitting the oven into is
of the size given in the above diagram.
o The oven must be fitted into an oven housing with the ventilation
cut-outs shown in the "Ventilation requirements" section on the
next page.
o Ensure that the rear panel of the furniture housing unit has been
removed.
ock, in order to gain access to the contacts
cement which can be obtained from the
ppliance
26
Advertisement
Table of Contents
